2.36 in. (60 mm) 5-Phase Stepper Motor - PK569PMB

Product specifications for PK569PMB

The PK569PMB specifies: The High-Resolution, high-performance stepper motor offers superior performance, increased positional accuracy (2 Arc minutes - 0.034º) highest torque (1.3 ~ 1.5 times a standard), lowest vibration and lowest noise. Basic step angle is 0.36º (1,000 steps per rev)., Motor cable required for connection (see Accessories), DC Driver input type motor only, ,

Frame Size	- 2.36 in, 60 mm
Motor Length	- 3.43 in., 87 mm
Basic Step Angle	- 0.36º
Speed-Torque Characteristics	-
Holding Torque
Holding Torque	- 320 oz-in, 2.3 N·m
Current per Phase	- 1.4 A/phase
Type	- High-Resolution
Shaft/Gear Type	- Round Shaft (No Gearhead)
Gear Type	- No Gearhead
Motor Connection Type	- Connector
Shaft	- Double
Step Angle	- 0.36 °
Connection Type	- New Pentagon (Bipolar)
Lead Wires	- 5
Rotor Inertia	- 5.3 oz-in², 970x10-7 kg·m²
RoHS Compliant	- Yes
Safety Standards	- UL, CSA, CE
Insulation Resistance	- 100 MΩ minimum under normal temperature and humidity, when measured by a 500 VDC megger between the windings and the motor casing.
Dielectric Strength	- Sufficient to withstand 1.5 kV, 50 Hz or 60 Hz applied for one minute between the windings and casing, under normal temperature and humidity.
Temperature Rise	- Temperature rise of the coil measured by the Change Resistance Method is 176ºF (80ºC) or less (at rated current, at standstill, five phases energized).
Insulation Class	- Class B [266ºF (130ºC)], Recognized as Class A 221ºF (105ºC) by UL standard
Ambient Temperature Range	- 14ºF ~ 122ºF (-10ºC ~ 50ºC) (nonfreezing)
Ambient Humidity	- 85% or less (noncondensing)
Shaft Runout	- 0.002 in. (0.05 mm) T.I.R. at top of output shaft
Concentricity	- 0.003 in. (0.075 mm) T.I.R.
Perpendicularity	- 0.003 in. (0.075 mm) T.I.R.
Radial Play	- 0.001 in. (0.025 mm) max. of 1.12 lb. (5 N)
Axial Play	- 0.003 in. (0.075 mm) max. of 2.2 lb. (10 N)
Radial Load	- 0 in. from Shaft End = 20 lb, 0.2 in. from Shaft End = 22 lb, 0.39 in. from Shaft End = 29 lb, 0.59 in. from Shaft End = 40 lb, 0.79 in. from Shaft End = 60 lb, 0 mm from Shaft End = 90 N, 5 mm from Shaft End = 100 N, 10 mm from Shaft End = 130 N, 15 mm from Shaft End = 180 N, 20 mm from Shaft End = 270 N
Axial Load	- 4.5 lb, 20 N